The tile floor heating system from Amuheat Floor Heating comprise of a single, insulated electric conductive heating element or hot water filled PEX pipes installed beneath the tile floor finish.

Amuheat Cable Strip tile floor heating system offers a 1mm thin heating cable pre configured on double sided adhesive tape with a heat distribution at 160W/m². It is installed above the subfloor directly under tile and stone. A range of cable strip sizes available in 240V is easily configured on site to suit any room layout.

An alternative option to electric tile floor heating systems is hydronic floor heating. The Speedfit Underfloor heating system is designed for use in screed beds with a heat distribution at 75w/m². The 15mm PEX pipes is installed on top of a 50mm insulation board before the screed topping and floor finish is laid.

The tile floor heating systems by Amuheat are safe. All electric heaters are tested in compliance with IEC 60335-1:2001, EN50082-1:1992 and are UL listed.

The heaters connected to a safety switch assure the system is safe from shock and fire risk, even in wet areas. The hydronic system uses low voltage controllers and typically relies on gas and/or solar energy for economical use.

Amuheat cable strip tile floor heating system makes floor heating simple when choosing and installing a tile floor heating system. Direct sales, support, specification, design and installation teams all make up Amuheat's service offering.